- Le plus récent
- Le plus de votes
- La plupart des commentaires
Check if you have configured Bidirectional Forwarding Detection (BFD). BFD is a simple hello mechanism that detects failures in a network.
BFD is not configured between the peers and I am not sure its even supported on the AWS side while configuring over IPSEC.
Regardless we don't seem to converge within 10seconds so i doubt BFD configuration if possible would make any difference.
BFD needs to configure on Direct connect. you need to check with your vendor.
check below link for example.
https://aws.amazon.com/premiumsupport/knowledge-center/enable-bfd-direct-connect/
As I have mentioned in my question, we are using the IPSEC tunnels and not direct connect so not sure how I can use BFD in my scenario. I know BFD is supported on direct connect but the problem is related to IPSEC tunnel convergence.
Contenus pertinents
- demandé il y a un an
- demandé il y a 7 mois
- demandé il y a 3 mois
- AWS OFFICIELA mis à jour il y a un an
- Comment connecter différentes succursales à l'aide de AWS Site-to-Site VPN et d'AWS Direct Connect ?AWS OFFICIELA mis à jour il y a un an
- AWS OFFICIELA mis à jour il y a 9 mois
- AWS OFFICIELA mis à jour il y a un an