- Più recenti
- Maggior numero di voti
- Maggior numero di commenti
There should be a "Gem.Water.Editor.<blabla>.dll" in the directory where you start the editor.
In the editor it should show up under "add component"->Environment->Infinite ocean.
In the projectconfigurator make sure that your project is selected as the default project.
If you're building using visual studio, run "lmbr_waf.bat show_option_dialog" and check in Visual Studio Project Generator tab generate_vs_projects_automatically. This will regenerate your solution file in the dir solutions.
run lmbr_waf.bat configure
Then either open the solution file and build using visual studio (change for now debug to profile to test it) or run
lmbr_waf.bat build_win_x64_vs2015_profile
(assuming 64bit and vs2015)
the binaries should be in the directory: bin64vc140
For debug builds change "profile" to "debug" and the final dir is bin64vc140.debug
I dont seem to have that file. I have the Gem file that shows all the ones enabled in the project. I also dont seem to have the option listed below. This is with the newest version currect?
I have done the steps above all over again as i did them already before i made this thread. Its the same as before. its enabled and shows in advanced settings and there is the file there but still unable to add and no option to add in the editor.
Questo post è chiuso: l'aggiunta di nuove risposte, commenti e voti è disabilitata.
Contenuto pertinente
- AWS UFFICIALEAggiornata 2 anni fa
- AWS UFFICIALEAggiornata 2 anni fa